Toyota
Dodge Durango
 Service Manual
Fuel System » Fuel injection system » Description and operation
Throttle position sensor (tps)-pcm input

DESCRIPTION

The 3-wire Throttle Position Sensor (TPS) is mounted on the throttle body and is connected to the throttle blade.

OPERATION

The TPS is a 3-wire variable resistor that provides the Powertrain Control Module (PCM) with an input signal (voltage) that represents the throttle blade position of the throttle body. The sensor is connected to the throttle blade shaft. As the position of the throttle blade changes, the resistance (output voltage) of the TPS changes.

The PCM supplies approximately 5 volts to the TPS. The TPS output voltage (input signal to the PCM) represents the throttle blade position. The PCM receives an input signal voltage from the TPS.

This will vary in an approximate range of from.26 volts at minimum throttle opening (idle), to 4.49 volts at wide open throttle. Along with inputs from other sensors, the PCM uses the TPS input to determine current engine operating conditions. In response to engine operating conditions, the PCM will adjust fuel injector pulse width and ignition timing.

The PCM needs to identify the actions and position of the throttle blade at all times. This information is needed to assist in performing the following calculations:

  • Ignition timing advance
  • Fuel injection pulse-width
  • Idle (learned value or minimum TPS)
  • Off-idle (0.06 volt)
  • Wide Open Throttle (WOT) open loop (2.608 volts above learned idle voltage)
  • Deceleration fuel lean out
  • Fuel cutoff during cranking at WOT (2.608 volts above learned idle voltage)
  • A/C WOT cutoff (certain automatic transmissions only)
    More about «Description and operation»:

    Powertrain control module (pcm)

    Modes of operation

    Automatic shutdown (asd) relay sense-pcm input

    Battery voltage-pcm input

    Brake switch-pcm input

    Engine coolant temperature sensor-pcm input

    Five volt sensor supplies-primary and secondary

    Ignition circuit sense-pcm input

    Intake manifold air temperature sensor-pcm input

    Manifold absolute pressure (map) sensor-pcm input

    Oil pressure sensor-pcm input

    Oxygen sensor (o2s)-pcm input

    Power grounds

    Power steering pressure switch- pcm input

    Sensor return-pcm input

    Throttle position sensor (tps)-pcm input

    Vehicle speed and distance-pcm input

    Auto shutdown (asd) relay-pcm output

    Ccd bus (+/-) circuits-pcm outputs

    Data link connector-pcm input and output

    Fuel injectors-pcm output

    Fuel pump relay-pcm output

    Idle air control (iac) motor-pcm output

    Oxygen sensor heater relays-pcm output

    Radiator cooling fan relay-pcm output

    Throttle body

    Dodge Durango Service Manual / Fuel System / Fuel injection system / Description and operation / Throttle position sensor (tps)-pcm input

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0052