Sunglasses storage bin. Garage door opener storage bin door

Sunglasses storage bin

REMOVAL

(1) Disconnect and isolate the battery negative cable.

(2) Remove the reading and courtesy lamp housing from the overhead console. Refer to Overhead Console Reading and Courtesy Lamp Housing in the Removal and Installation section of this group for the procedures.

(3) Unlatch and remove the sunglasses storage bin from the overhead console housing.

INSTALLATION

(1) Position the sunglasses storage bin into the overhead console housing.

(2) Engage the latch of the sunglasses storage bin with the latch striker on the rear of the storage bin opening in the overhead console housing.

(3) Be certain that the sunglasses storage bin pivot shaft is located in the two pivot receptacles just behind the reading and courtesy lamp lenses in the overhead console housing.

(4) Be certain that the sunglasses storage bin damper spring is installed on the pivot shaft with the two end tabs of the spring engaged with the flats on the rear of the shaft, and the center tab engaged over the front of the shaft.

(5) Install the reading and courtesy lamp housing onto the overhead console. Refer to Overhead Console Reading and Courtesy Lamp Housing in the Removal and Installation section of this group for the procedures.

(6) Reconnect the battery negative cable.

Garage door opener storage bin door

REMOVAL

(1) Disconnect and isolate the battery negative cable.

(2) Remove the overhead console from the headliner.

Refer to Overhead Console in the Removal and Installation section of this group for the procedures.

(3) Remove the two screws that secure the garage door opener storage bin door pivot and bumper block to the overhead console housing (Fig. 9).

Fig. 9 Garage Door Opener Storage Bin Door Remove/Install Fig. 9 Garage Door Opener Storage Bin Door Remove/Install

1 - SPRING CLIPS

2 - SUNGLASSES STORAGE BIN

3 - GARAGE DOOR OPENER STORAGE BIN DOOR

4 - PIVOT AND BUMPER BLOCK

5 - SCREW (2)

(4) Remove the garage door opener storage bin door pivot and bumper block from the overhead console housing.

(5) Unlatch and remove the garage door opener storage bin door from the overhead console housing.

INSTALLATION

(1) Position the garage door opener storage bin door into the overhead console housing.

(2) Engage the latch of the garage door opener storage bin door with the latch striker on the rear of the storage bin opening in the overhead console housing.

(3) Be certain that both garage door opener storage bin door pivot pins are located in the two pivot receptacles in the overhead console housing just behind the sunglasses storage bin.

(4) Position the garage door opener storage bin door pivot and bumper block onto the overhead console housing.

(5) Install and tighten the two screws that secure the garage door opener storage bin door pivot and bumper block to the overhead console housing.

Tighten the screws to 2.2 N*m (20 in. lbs.).

(6) Install the overhead console onto the headliner.

Refer to Overhead Console in the Removal and Installation section of this group for the procedures.

(7) Reconnect the battery negative cable.

    Dodge Durango (DN) 1998-2003 Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net