Toyota
Dodge Durango
 Service Manual
Suspension » Rear suspension » Removal and installation
Stabilizer bar

REMOVAL

(1) Raise and support vehicle.

(2) Remove links upper mounting nuts and bolts.

(3) Remove the cotter pins and nuts from the links at the stabilizer bar.

(4) Separate the links from the stabilizer bar with Puller C-3894-A and remove the links.

(5) Remove stabilizer bar retainer bolts and retainers (Fig. 3).

(6) Remove stabilizer bar and remove bushings.

Fig. 3 Stabilizer Bar Mounting Fig. 3 Stabilizer Bar Mounting

1 - LINK

2 - STABILIZER BAR

3 - RETAINER

INSTALLATION

(1) Install stabilizer bar bushings.

(2) Install the stabilizer bar and center it with equal spacing on both sides.

(3) Install stabilizer bar retainers and tighten bolts to 54 N*m (40 ft. lbs.).

(4) Install link on the frame and the stabilizer bar.

Install mounting bolts and nuts.

(5) Remove support and lower vehicle.

(6) Tighten stabilizer link upper nuts to 95 N*m (70 ft. lbs.).

(7) Tighten stabilizer link lower nuts to 68 N*m (50 ft. lbs.) and install a new cotter pins.

    More about «Removal and installation»:

    Shock absorber

    Stabilizer bar

    Leaf springs

    Dodge Durango Service Manual / Suspension / Rear suspension / Removal and installation / Stabilizer bar

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0053