Toyota
Dodge Durango
 Service Manual
Heating and Air Conditioning » Description and operation
Refrigerant system service ports

DESCRIPTION

The two refrigerant system service ports are used to charge, recover/recycle, evacuate, and test the air conditioning refrigerant system. Unique service port coupler sizes are used on the R-134a system, to ensure that the refrigerant system is not accidentally contaminated by the use of the wrong refrigerant (R-12), or refrigerant system service equipment.

OPERATION

The high pressure service port is located on the liquid line between the condenser and the evaporator, near the front of the engine compartment. The low pressure service port is located on the compressor manifold, directly over the suction port of the compressor.

Each of the service ports has a threaded plastic protective cap installed over it from the factory. After servicing the refrigerant system, always reinstall both of the service port caps.

    More about «Description and operation»:

    Blower motor

    Blower motor relay

    Blower motor resistor

    Blower motor switch

    Compressor

    Compressor clutch

    Compressor clutch relay

    Condenser

    Electronic cycling clutch switch

    Evaporator coil

    Expansion valve

    Filter-drier

    Heater and air conditioner

    Heater and air conditioner control

    Heater core

    High pressure cut-off switch

    High pressure relief valve

    Low pressure cut-off switch

    Rear overhead air conditioner

    Refrigerant

    Refrigerant lines

    Refrigerant line couplers

    Refrigerant oil

    Refrigerant system service ports

    Vacuum check valve

    Vacuum reservoir

    Dodge Durango Service Manual / Heating and Air Conditioning / Description and operation / Refrigerant system service ports

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0045