Toyota
Dodge Durango
 Service Manual
Brakes » Four wheel antilock brakes » Removal and installation
Rear wheel speed sensor

REMOVAL

(1) Raise vehicle on hoist.

(2) Remove brake line mounting nut and remove the brake line from the sensor stud.

(3) Remove mounting stud from the sensor and shield (Fig. 13).

(4) Remove sensor and shield from differential housing.

(5) Disconnect sensor wire harness and remove sensor.

Fig. 12 Tone Wheel 4x2 Fig. 12 Tone Wheel 4x2

1 - HUB

2 - TONE WHEEL

3 - BEARING

Fig. 13 Rear Speed Sensor Mounting Fig. 13 Rear Speed Sensor Mounting

1 - DIFFERENTIAL HOUSING

2 - WHEEL SPEED SENSOR

INSTALLATION

(1) Connect harness to sensor. Be sure seal is securely in place between sensor and wiring connector.

(2) Install O-ring on sensor (if removed).

(3) Insert sensor in differential housing.

(4) Install sensor shield.

(5) Install the sensor mounting stud and tighten to 24 N*m (200 in. lbs.).

(6) Install the brake line on the sensor stud and install the nut.

(7) Lower vehicle.

EXCITER RING

The exciter ring is mounted on the differential case. If the ring is damaged refer to Group 3 Differential and Driveline for service procedures.

Specifications

Torque chart

DESCRIPTION   TORQUE

ABS Assembly

Bracket bolts . . . . . . . . 14-15 N*m (10-12 ft. lbs.)

Mounting Nuts . . . . . . . . . . 12 N*m (102 in. lbs.)

CAB Screws . . . . . . . . . 4-4.7 N*m (36-42 in. lbs.)

Brake Line Fittings . . . . . . . 19 N*m (170 in. lbs.)

Wheel Speed Sensors

Front Sensor Bolt . . . . . . . . 21 N*m (190 in. lbs.)

Rear Sensor Bolt . . . . . . . 22.5 N.m (200 in. lbs.)

    More about «Removal and installation»:

    Controller antilock brakes

    Antilock control assembly

    Front wheel speed sensor - 4x2

    Front wheel speed sensor - 4x4

    Rear wheel speed sensor

    Dodge Durango Service Manual / Brakes / Four wheel antilock brakes / Removal and installation / Rear wheel speed sensor

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0025