Toyota
Dodge Durango
 Service Manual
Body » Stationary glass » Removal and installation
Rear door stationary glass

REMOVAL

(1) Remove trim panel.

(2) Remove waterdam.

(3) Remove inner beltline weatherstrip (4) Remove outer beltline weatherstrip.

(5) Remove door glass from door.

(6) Remove bolt attaching bottom of rearward run channel to door inner panel.

(7) Remove nuts attaching stationary glass to door (Fig. 6).

Fig. 5 Applicator Tip Fig. 5 Applicator Tip

1 - APPLICATOR TIP

(8) Separate rearward run channel/stationary glass from door.

(9) Pull to separate stationary glass from run channel.

Fig. 6 Rear Door Stationary Glass Fig. 6 Rear Door Stationary Glass

1 - RUN CHANNEL WITH STATIONARY GLASS

2 - REAR DOOR

3 - REGULATOR

4 - RUN CHANNEL

5 - DOOR GLASS

INSTALLATION

(1) Ensure glass and run channel are clean.

(2) Apply butyl adhesive to glass and insert in glass run channel.

(3) Install nuts attaching stationary glass to door.

Tighten nuts to 3 N*m (30 in. lbs.) torque (Fig. 6).

(4) Install bolt attaching bottom of rearward run channel to door inner panel.

(5) Position door glass in door.

(6) Install door glass to regulator.

(7) Install outer beltline weatherstrip.

(8) Install inner beltline weatherstrip (9) Install waterdam.

(10) Install trim panel.

    More about «Removal and installation»:

    Windshield

    Rear door stationary glass

    Quarter window glass

    Liftgate backlite

    Dodge Durango Service Manual / Body / Stationary glass / Removal and installation / Rear door stationary glass

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0083