REMOVAL
(1) Remove rivets at each side rear wheel well.
NOTE: Removing the step pad will damage the step pad retainers, verify availability of step pad from parts supplier.
(2) Using a trim stick, carefully pry step pad from fascia.
(3) Disconnect license plate lamp connector.
(4) Remove upper push pin from the bumper fascia (Fig. 3).
(5) Remove the lower push pins from the bumper fascia.
(6) Remove the bumper fascia from the bumper (Fig. 2).
Fig. 3 Rear Fascia
1 - LICENSE PLATE LAMP CONNECTOR
2 - FASCIA
3 - PUSH PIN
4 - RIVET
5 - PUSH PIN
6 - RIVET
INSTALLATION
(1) Position the bumper fascia on the bumper (Fig.2).
(2) Install upper push pin.
(3) Align all holes and install the lower push pins.
(4) Position step pad on fascia and press into place.
(5) Connect license plate lamp connector.
(6) Align fascia bracket, wheel house liner shield and fascia holes and install rivets.