Toyota
Dodge Durango
 Service Manual
Frame and Bumpers » Bumpers » Removal and installation
Rear bumper

REMOVAL

(1) Remove trailer hitch, if equipped.

(2) Raise and support the rear of the vehicle.

(3) Support the bumper.

(4) Remove rivets at each side rear wheel well.

(5) Disconnect license plate lamp wiring harness.

(6) Remove nuts attaching bumper support brackets to rear rails and crossmember (Fig. 2).

(7) Remove the bumper/fascia from the vehicle.

INSTALLATION

(1) Position the bumper/fascia on the vehicle.

Fig. 2 Rear Bumper Fig. 2 Rear Bumper

1 - BUMPER BEAM

2 - PUSH-PIN

3 - STEP PAD

4 - PUSH-PIN

5 - PUSH-PIN

6 - FASCIA

7 - SHIELD

8 - BLIND RIVET

9 - FASCIA BRACKET

10 - BUMPER BRACKET

11 - FRAME

(2) Install nuts attaching bumper support brackets to crossmember and rear rails (Fig. 2).

(3) Check gaps and fit. Adjust as necessary.

Tighten nuts to 54 N*m (40 ft. lbs.) torque.

(4) Connect license plate lamp wiring harness.

(5) If equipped, install the trailer hitch.

    More about «Removal and installation»:

    Front bumper

    Front bumper inner bracket

    Front bumper fascia

    Rear bumper

    Rear bumper fascia

    Dodge Durango Service Manual / Frame and Bumpers / Bumpers / Removal and installation / Rear bumper

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0025