(1) Disconnect and isolate the battery negative cable.
(2) Remove the trim panel from the inside of the front door. Refer to Group 23 - Body for the procedures.
(3) Remove the mirror flag seal from the inner door panel (Fig. 7).
(4) Unplug the wire harness connector from the power mirror (Fig. 8).
(5) Remove the three nuts that secure the power mirror to the inner door panel.
(6) Unseat the power mirror wire harness grommet by pushing it out through the hole in the door flag from the inside.
Fig. 7 Mirror Flag Seal Remove/Install
1 - WATER DAM
2 - MIRROR FLAG SEAL
Fig. 8 Power Mirror Remove/Install
1 - ELECTRIC FOLD AWAY SIDEVIEW MIRROR
2 - DOOR
3 - ELECTRIC SIDEVIEW MIRROR
(7) Pull the mirror from the outside of the door while feeding the wire harness, grommet, and connector out through the hole from the inside of the door.
(8) Reverse the removal procedures to install.
Tighten the mounting nuts to 7.5 N*m (65 in. lbs.).