Toyota
Dodge Durango
 Service Manual
Brakes » Base brake system » Removal and installation
Power brake booster

REMOVAL

(1) Remove master cylinder.

(2) Disconnect vacuum lines at booster.

(3) Remove clip securing booster push rod to brake pedal (Fig. 18).

(4) Remove nuts from booster mounting studs (Fig.

19).

(5) Remove booster, spacer and gaskets from front cowl panel.

Fig. 18 Booster Rod Clip Fig. 18 Booster Rod Clip

1 - BOOSTER ROD

2 - BRAKE PEDAL

3 - CLIP

Fig. 19 Power Brake Booster Mounting Fig. 19 Power Brake Booster Mounting

1 - BRAKE BOOSTER

2 - SPACER

3 - FRONT COWL PANEL

4 - BRAKE PEDAL

5 - BRAKE BOOSTER ROD

INSTALLATION

1) Position spacer and gaskets on booster studs.

(2) Guide booster studs into cowl panel holes and seat booster on panel.

(3) Install and tighten booster attaching nuts to 28 N*m (250 in. lbs.).

(4) Install booster push rod on brake pedal and install clip.

(5) Install booster check valve if removed and connect vacuum hose to check valve.

(6) Install master cylinder.

(7) Fill and bleed brake system.

    More about «Removal and installation»:

    Brake lamp switch

    Brake pedal

    Combination valve

    Master cylinder

    Power brake booster

    Disc brake caliper

    Disc brake shoes

    Disc brake rotor

    Rear brake shoes

    Wheel cylinder

    Brake support plate

    Front park brake cable

    Rear park brake cables

    Park brake pedal assembly

    Dodge Durango Service Manual / Brakes / Base brake system / Removal and installation / Power brake booster

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0215