Toyota
Dodge Durango
 Service Manual
Instrument Panel Systems » Removal and installation
Park brake release handle

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

REMOVAL

(1) Disconnect and isolate the battery negative cable.

(2) Reach under the driver side outboard end of the instrument panel to access and unsnap the plastic retainer clip that secures the park brake release linkage rod to the lever on the back side of the park brake release handle.

(3) Disengage the park brake release linkage rod end from the lever on the back of the park brake release handle.

(4) Using a trim stick or another suitable wide flat-bladed tool, gently pry one of the park brake handle hinge tabs away from its pivot pin on the instrument panel (Fig. 10).

(5) While prying the park brake release handle hinge tab with one hand, use the other hand to pull the handle firmly down and away from the pivot pin.

(6) Remove the park brake release handle from the instrument panel.

INSTALLATION

(1) Position the park brake release handle to the instrument panel.

(2) Engage one of the park brake release handle hinge tabs with one of the pivot pins on the instrument panel.

(3) Align the second park brake release handle hinge tab hinge over the second pivot pin on the instrument panel.

(4) Press firmly on the park brake release handle over the second hinge tab until it snaps over the second pivot pin on the instrument panel.

Fig. 10 Park Brake Release Handle Remove/Install Fig. 10 Park Brake Release Handle Remove/Install

1 - INSERT BETWEEN HINGE TAB AND PIVOT PIN

2 - TRIM STICK

3 - PARK BRAKE RELEASE HANDLE

4 - INSTRUMENT PANEL

(5) Reach under the driver side outboard end of the instrument panel to access and engage the park brake release linkage rod end from the lever on the back of the park brake release handle.

(6) Snap the plastic retainer clip that secures the park brake release linkage rod to the lever on the back side of the park brake release handle over the linkage rod.

(7) Reconnect the battery negative cable.

    More about «Removal and installation»:

    Cluster bezel

    Headlamp switch

    Instrument cluster

    Instrument cluster components

    Steering column opening cover

    Gear selector indicator

    Park brake release handle

    Instrument panel lower reinforcement

    Instrument panel center support bracket

    Instrument panel ash receiver

    Instrument panel lower bezel

    Instrument panel cigar lighter and power outlet

    Glove box lamp and switch

    Glove box latch striker

    Glove box

    Glove box components

    Central timer module

    Instrument panel assembly

    Instrument panel top cover

    Dodge Durango Service Manual / Instrument Panel Systems / Removal and installation / Park brake release handle

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0026