Toyota
Dodge Durango
 Service Manual
Transmission and Transfer Case » Removal and installation
Output shaft rear bearing

REMOVAL

(1) Remove overdrive unit from the vehicle.

(2) Remove overdrive geartrain from housing.

(3) Remove snap ring holding output shaft rear bearing into overdrive housing (Fig. 97).

(4) Using a suitable driver inserted through the rear end of housing, drive bearing from housing.

INSTALLATION

(1) Place replacement bearing in position in housing.

(2) Using a suitable driver, drive bearing into housing until the snap ring groove is visible.

(3) Install snap ring to hold bearing into housing (Fig. 97).

(4) Install overdrive geartrain into housing.

(5) Install overdrive unit in vehicle.

Fig. 97 Output Shaft Rear Bearing Fig. 97 Output Shaft Rear Bearing

1 - OUTPUT SHAFT REAR BEARING

2 - OVERDRIVE HOUSING

3 - SNAP RING

    More about «Removal and installation»:

    Transmission

    Torque converter

    Yoke seal replacement

    Park/neutral position switch

    Gearshift cable

    Governor solenoid and pressure sensor

    Valve body

    Overdrive unit

    Overdrive housing bushing

    Output shaft rear bearing

    Output shaft front bearing

    Dodge Durango Service Manual / Transmission and Transfer Case / Removal and installation / Output shaft rear bearing

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0048