Toyota
Dodge Durango
 Service Manual
Engine » Removal and installation
Oil pump

REMOVAL

(1) Remove the oil pan and pick-up tube. Refer to the procedure in this section.

(2) Remove the timing chain cover. Refer to the procedure in this section.

(3) Remove the timing chains and tensioners.

Refer to Timing Chain and Sprockets in this section.

(4) Remove the four bolts, primary timing chain tensioner and the oil pump.

INSTALLATION

(1) Position the oil pump onto the crankshaft and install two oil pump retaining bolts.

(2) Position the primary timing chain tensioner and install the two retaining bolts.

(3) Tighten the oil pump and primary timing chain tensioner retaining bolts to 28 N*m (250 in. lbs.) in the sequence shown (Fig. 124).

(4) Install the secondary timing chain tensioners and timing chains.

(5) Install the timing chain cover.

(6) Install the pick-up tube and oil pan.

Fig. 121 Bedplate Tightening Sequence Fig. 121 Bedplate Tightening Sequence

    More about «Removal and installation»:

    Engine mounts-left and right

    Engine mount-rear

    Structural cover

    Engine assembly

    Intake manifold

    Exhaust manifolds

    Cylinder head cover

    Rocker arms

    Cylinder heads

    Valve springs and seals

    Hydraulic lash adjuster

    Crankshaft damper

    Timing chain cover

    Timing chain and sprockets

    Idler shaft-timing drive

    Camshafts-in vehicle

    Crankshaft main bearings

    Oil pan 4x2 vehicle

    Oil pan 4x4 vehicle

    Piston and connecting rod

    Crankshaft

    Flexplate

    Oil pump

    Engine oil pressure sending unit

    Crankshaft oil seal-front

    Crankshaft oil seal-rear

    Engine core plugs

    Dodge Durango Service Manual / Engine / Removal and installation / Oil pump

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0047