Dodge Durango
Owners Manual
Starting and operating » Starting procedures
Normal Starting
To Turn On The Engine Using The ENGINE
START/STOP Button
- The transmission must be in PARK or NEUTRAL.
- Press and hold the brake pedal while pushing the
ENGINE START/STOP button once.
- The system takes over and attempts to start the
vehicle. If the vehicle fails to start, the starter will
disengage automatically after 10 seconds.
- If you wish to stop the cranking of the engine prior to
the engine starting, push the button again.
NOTE: Normal starting of either a cold or a warm engine
is obtained without pumping or pressing the accelerator
pedal.
To Turn Off The Engine Using ENGINE
START/STOP Button
- Place the gear selector in PARK, then push and release
the ENGINE START/STOP button.
- The ignition switch will return to the OFF position.
- If the gear selector is not in PARK, the ENGINE
START/STOP button must be held for two seconds or
three short pushes in a row with the vehicle speed
above 5 mph (8 km/h) before the engine will shut off.The ignition switch position will remain in the ACC
position until the gear selector is in PARK and the
button is pushed twice to the OFF position. If the gear
selector is not in PARK and the ENGINE START/
STOP button is pushed once, the DID will display a
"Vehicle Not In Park" message and the engine will
remain running. Never leave a vehicle out of the
PARK position, or it could roll.
- If the gear selector is in Neutral, push and release the
ENGINE START/STOP button with the vehicle speed
below 5 mph (8 km/h) before the engine will shut off.The ignition switch position will remain in the ACC
position.
NOTE: If the ignition switch is left in the ACC or RUN
(engine not running) position and the transmission is in
PARK, the system will automatically time out after 30
minutes of inactivity and the ignition will switch to the
OFF position.
ENGINE START/STOP Button Functions - With
Driver's Foot OFF The Brake Pedal (In PARK Or
NEUTRAL Position)
The ENGINE START/STOP button operates similar to an
ignition switch. It has four positions, OFF, ACC, RUN
and START. To change the ignition positions without
starting the vehicle and use the accessories, follow these
steps:
- Starting with the ignition in the OFF position.
- Push the ENGINE START/STOP button once to place
the ignition to the ACC position (DID will display
"ACC").
- Push the ENGINE START/STOP button a second time
to place the ignition to the RUN position (DID will
display "ON/RUN").
- Push the ENGINE START/STOP button a third time to
return the ignition to the OFF position (DID will
display "OFF").
Extreme Cold Weather (Below -22F Or −30C)
To ensure reliable starting at these temperatures, use of
an externally powered electric engine block heater (available
from your authorized dealer) is recommended.
More about «Starting procedures»:
Normal Starting