Toyota
Dodge Durango
 Service Manual
Brakes » Base brake system » Disassembly and assembly
Master cylinder reservoir

REMOVAL

(1) Remove reservoir cap and empty fluid into drain container.

(2) Clamp cylinder body in vise with brass protective jaws.

(3) Remove pins that retain reservoir to master cylinder. Use hammer and pin punch to remove pins (Fig. 40).

Fig. 40 Reservoir Retaining Pins Fig. 40 Reservoir Retaining Pins

1 - PIN PUNCH

2 - RESERVOIR

3 - BODY

4 - ROLL PINS

(4) Loosen reservoir from grommets with pry tool (Fig. 41).

Fig. 41 Loosening Reservoir Fig. 41 Loosening Reservoir

1 - PRYTOOL

2 - RESERVOIR

3 - GROMMET

4 - MASTER CYLINDER BODY

(5) Remove reservoir by rocking it to one side and pulling free of grommets (Fig. 42).

(6) Remove old grommets from cylinder body (Fig.

43).

Fig. 42 Reservoir Removal Fig. 42 Reservoir Removal

1 - RESERVOIR

2 - GROMMETS

Fig. 43 Grommet Removal Fig. 43 Grommet Removal

1 - MASTER CYLINDER BODY

2 - GROMMETS

INSTALLATION

CAUTION: Do not use any type of tool to install the grommets. Tools may cut, or tear the grommets creating a leak problem after installation. Install the grommets using finger pressure only.

(1) Lubricate new grommets with clean brake fluid and Install new grommets in cylinder body (Fig. 44).

Use finger pressure to install and seat grommets.

(2) Start reservoir in grommets. Then rock reservoir back and forth while pressing downward to seat it in grommets.

(3) Install pins that retain reservoir to cylinder body.

(4) Fill and bleed master cylinder on bench before installation in vehicle.

    More about «Disassembly and assembly»:

    Master cylinder reservoir

    Disc brake caliper

    Wheel cylinder

    Dodge Durango Service Manual / Brakes / Base brake system / Disassembly and assembly / Master cylinder reservoir

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0024