Dodge Durango

 Service Manual

Fuel System » Fuel injection system » Removal and installation
Manifold absolute pressure (map) sensor-3.9/5.2/5.9L engines

The MAP sensor is located on the front of the throttle body (Fig. 26). An L-shaped rubber fitting is used to connect the MAP sensor to throttle body (Fig.

27).

REMOVAL

(1) Remove air duct at throttle body.

(2) Remove two MAP sensor mounting bolts (screws) (Fig. 26).

Fig. 26 MAP Sensor Location-3.9/5.2/5.9L Engines

1 - MAP SENSOR

2 - MOUNTING SCREWS (2)

Fig. 27 MAP Sensor L-Shaped Rubber Fitting-3.9/ 5.2/5.9L Engines

1 - MAP SENSOR

2 - RUBBER FITTING

3 - IDLE AIR PASSAGE

(3) While removing MAP sensor, slide the vacuum rubber L-shaped fitting (Fig. 27) from the throttle body.

(4) Remove rubber L-shaped fitting from MAP sensor.

INSTALLATION

(1) Install rubber L-shaped fitting to MAP sensor.

(2) Position sensor to throttle body while guiding rubber fitting over throttle body vacuum nipple.

(3) Install MAP sensor mounting bolts (screws).

Tighten screws to 3 N*m (25 in. lbs.) torque.

(4) Install air duct at throttle body.

Automatic shutdown (asd) relay

Fuel pump relay

Oxygen sensor heater relays

Throttle body-3.9/5.2/5.9L engines

Throttle body-4.7L v-8 engine

Throttle position sensor (tps)-3.9/ 5.2/5.9L engines

Throttle position sensor (tps)-4.7L v-8 engine

Idle air control (iac) motor-3.9/5.2/ 5.9L engines

Idle air control (iac) motor-4.7L v-8 engine

Manifold absolute pressure (map) sensor-3.9/5.2/5.9L engines

Manifold absolute pressure (map) sensor-4.7L v-8 engine

Powertrain control module (pcm)

Oxygen sensor

Air cleaner element (filter)

Engine coolant temperature sensor-3.9/5.2/5.9L engines

Engine coolant temperature sensor-4.7L v-8 engine

Intake manifold air temperature sensor-3.9/5.2/5.9L engines

Intake manifold air temperature sensor-4.7L v-8 engine

Power steering pressure switch