Toyota
Dodge Durango
 Service Manual
Vehicle Theft/Security Systems » Removal and installation
Liftgate lock cylinder switch

(1) Disconnect and isolate the battery negative cable.

(2) Remove the trim panel from the liftgate inner panel. Refer to Group 23 - Body for the procedures.

Fig. 2 Door Lock Cylinder Switch Remove/Install - Typical Fig. 2 Door Lock Cylinder Switch Remove/Install - Typical

1 - DOOR OUTSIDE LATCH HANDLE

2 - DOOR

3 - DOOR LOCK CYLINDER SWITCH

4 - CONNECTOR

5 - RETAINERS

(3) Reach through the access hole in the liftgate inner panel to disengage the switch from the back of the liftgate lock cylinder (Fig. 3).

Fig. 3 Liftgate Lock Cylinder Switch Remove/Install Fig. 3 Liftgate Lock Cylinder Switch Remove/Install

1 - LIFTGATE INNER PANEL

2 - LIFTGATE LATCH OUTSIDE HANDLE

3 - LIFTGATE LOCK CYLINDER SWITCH

4 - WIRE HARNESS CONNECTOR

(4) Unplug the liftgate lock cylinder switch wire harness connector.

(5) Remove the liftgate lock cylinder switch from the liftgate.

(6) Reverse the removal procedures to install.

    More about «Removal and installation»:

    Door ajar switch

    Door lock cylinder switch

    Liftgate lock cylinder switch

    Headlamp relay

    Horn relay

    Dodge Durango Service Manual / Vehicle Theft/Security Systems / Removal and installation / Liftgate lock cylinder switch

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0044