Toyota
Dodge Durango
 Service Manual
Wiper and Washer Systems » Removal and installation
Intermittent wipe relay

(1) Disconnect and isolate the battery negative cable.

(2) Remove the cover from the Power Distribution Center (PDC) (Fig. 16).

Fig. 16 Power Distribution Center Fig. 16 Power Distribution Center

1 - CLIP

2 - BATTERY

3 - TRAY

4 - NEGATIVE CABLE

5 - POSITIVE CABLE

6 - CLIP

7 - FENDER INNER SHIELD

8 - POWER DISTRIBUTION CENTER

(3) Refer to the label on the PDC cover for intermittent wipe relay identification and location.

(4) Unplug the intermittent wipe relay from the PDC.

(5) Install the intermittent wipe relay by aligning the relay terminals with the cavities in the PDC and pushing the relay firmly into place.

(6) Install the PDC cover.

(7) Connect the battery negative cable.

(8) Test the relay operation.

    More about «Removal and installation»:

    Wiper blade

    Wiper arm

    Wiper motor

    Intermittent wipe relay

    Wiper switch and washer switch

    Washer system

    Dodge Durango Service Manual / Wiper and Washer Systems / Removal and installation / Intermittent wipe relay

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.005