Toyota
Dodge Durango
 Owners Manual
Things to know before starting your vehicle » Occupant restraint systems » Child Restraints
Installing A Child Restraint With A Switchable Automatic Locking Retractor (ALR)

  1. Place the child seat in the center of the seating position. For some second row seats, you may need to recline the seat and/or raise the head restraint to get a better fit. If the rear seat can be moved forward and rearward in the vehicle, you may wish to move it to its rear-most position to make room for the child seat.You may also move the front seat forward to allow more room for the child seat.
  2.  Pull enough of the seat belt webbing from the retractor to pass it through the belt path of the child restraint.Do not twist the belt webbing in the belt path.
  3.  Slide the latch plate into the buckle until you hear a "click."
  4.  Pull on the webbing to make the lap portion tight against the child seat.
  5.  To lock the seat belt, pull down on the shoulder part of the belt until you have pulled all the seat belt webbing out of the retractor. Then, allow the webbing to retract back into the retractor. As the webbing retracts, you will hear a clicking sound. This means the seat belt is now in the Automatic Locking mode.
  6.  Try to pull the webbing out of the retractor. If it is locked, you should not be able to pull out any webbing.If the retractor is not locked, repeat step 5.
  7.  Finally, pull up on any excess webbing to tighten the lap portion around the child restraint while you push the child restraint rearward and downward into the vehicle seat.
  8.  If the child restraint has a top tether strap and the seating position has a top tether anchorage, connect the tether strap to the anchorage and tighten the tether strap. See the section "Installing Child Restraints Using The Top Tether Anchorage" for directions to attach a tether anchor.
  9. Test that the child restraint is installed tightly by pulling back and forth on the child seat at the belt path. It should not move more than 1 inch (25.4 mm) in any direction.

Any seat belt system will loosen with time, so check the belt occasionally, and pull it tight if necessary

    More about «Child Restraints»:

    Infants And Child Restraints

    Older Children And Child Restraints

    Children Too Large For Booster Seats

    Lower Anchors And Tethers For CHildren (LATCH) Restraint System

    LATCH Positions For Installing Child Restraints In This Vehicle

    Locating LATCH Anchorages

    Locating Tether Anchorages

    Center Arm Rest Tether

    To Install A LATCH-Compatible Child Restraint

    How To Stow An Unused Switchable (ALR) Seat Belt

    Installing Child Restraints Using the Vehicle Seat Belt

    Lap/Shoulder Belt Systems For Installing Child Restraints In This Vehicle

    Installing A Child Restraint With A Switchable Automatic Locking Retractor (ALR)

    Installing Child Restraints Using the Top Tether Anchorage

    Dodge Durango Owners Manual / Things to know before starting your vehicle / Occupant restraint systems / Child Restraints / Installing A Child Restraint With A Switchable Automatic Locking Retractor (ALR)

    Dodge Durango Owners Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0049