Toyota
Dodge Durango
 Service Manual
Horn Systems » Removal and installation
Horn

REMOVAL

(1) Disconnect and isolate the battery negative cable.

(2) Disconnect the headlamp and dash wire harness connectors from the horn connector receptacles (Fig. 3).

Fig. 3 Horns Remove/Install Fig. 3 Horns Remove/Install

1 - RADIATOR SUPPORT

2 - HEADLAMP AND DASH WIRE HARNESS

3 - LOW NOTE

4 - SCREW

5 - HORN AND BRACKET

6 - HIGH NOTE

(3) Remove the screw that secures the horn and mounting bracket unit to the front of the left vertical member of the radiator support.

(4) Remove the horn and mounting bracket unit from the radiator support.

INSTALLATION

(1) Position the horn and mounting bracket unit onto the front of the left vertical member of the radiator support.

(2) Install and tighten the screw that secures the horn and mounting bracket unit to the radiator support.

Tighten the screw to 10.7 N*m (95 in. lbs.).

(3) Reconnect the headlamp and dash wire harness connectors to the horn connector receptacles.

(4) Reconnect the battery negative cable.

    More about «Removal and installation»:

    Horn relay

    Horn

    Dodge Durango Service Manual / Horn Systems / Removal and installation / Horn

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0024