Toyota
Dodge Durango
 Service Manual
Fuel System » Fuel delivery system » Removal and installation
Fuel injector(s)

WARNING: THE FUEL SYSTEM IS UNDER A CONSTANT PRESSURE EVEN WITH ENGINE TURNED OFF. BEFORE SERVICING FUEL INJECTOR(S), FUEL SYSTEM PRESSURE MUST BE RELEASED.

To release fuel pressure, refer to Fuel System Pressure Release Procedure.

To remove one or more fuel injectors, fuel rail assembly must be removed from engine.

REMOVAL

(1) Remove air cleaner assembly.

(2) Remove fuel injector rail assembly. Refer to Fuel Injector Rail Removal/Installation in this group.

(3) Remove clip(s) retaining the injector(s) to fuel rail (Fig. 32) or (Fig. 33).

(4) Remove injector(s) from fuel rail.

INSTALLATION

(1) Apply a small amount of clean engine oil to each fuel injector o-ring. This will help in fuel rail installation.

(2) Install injector(s) and injector clip(s) to fuel rail.

(3) Install fuel rail assembly. Refer to Fuel Injector Rail Removal/Installation.

(4) Install air cleaner.

(5) Start engine and check for leaks.

    More about «Removal and installation»:

    Fuel filter/fuel pressure regulator

    Fuel pump module

    Fuel pump inlet filter

    Fuel gauge sending unit

    Fuel injector rail-3.9/5.2/5.9L engines

    Fuel injector rail-4.7L v-8 engine

    Fuel injector(s)

    Fuel tank

    Fuel tank filler tube cap

    Accelerator pedal

    Throttle cable

    Throttle cable-4.7L v-8 engine

    Dodge Durango Service Manual / Fuel System / Fuel delivery system / Removal and installation / Fuel injector(s)

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0029