Toyota
Dodge Durango
 Service Manual
Frame and Bumpers » Bumpers » Removal and installation
Front bumper

REMOVAL

(1) Open hood.

(2) Support front bumper on a suitable lifting device.

(3) Disengage wire connectors from fog lamps, if equipped.

(4) Disengage push-in fasteners attaching air deflector to bottom of bumper fascia.

(5) Pull the front wheelhouse liner back at the bumper and remove bolts attaching outer bumper brackets to frame rail (Fig. 1).

(6) Remove the bolts attaching the bumper to the inner bumper bracket.

(7) Separate front bumper with outer bracket attached from vehicle.

INSTALLATION

When the front bumper is installed, there should be a 19 mm gap between the bumper and front fender.

(1) Place the bumper on a suitable lifting device and position the bumper at the vehicle.

(2) Install the bolts attaching front bumper to inner bumper bracket. Tighten to 94 N*m (70 ft. lbs.) torque.

(3) Install the bolts attaching outer bumper brackets to the frame rail. Tighten to 94 N*m (70 ft. lbs.) torque. Ensure front wheelhouse liners are positioned correctly behind bumper.

(4) Engage wire connectors to fog lamps, if equipped.

(5) Install push-in fasteners attaching air deflector to front bumper fascia.

(6) Remove lifting device.

(7) Close hood.

Fig. 1 Front Bumper Fig. 1 Front Bumper

1 - FOG LAMP

2 - FRONT BUMPER

3 - OUTER BUMPER BRACKET

4 - U-NUT

5 - FRAME

6 - INNER BUMPER BRACKET

7 - FASCIA BRACKET

    More about «Removal and installation»:

    Front bumper

    Front bumper inner bracket

    Front bumper fascia

    Rear bumper

    Rear bumper fascia

    Dodge Durango Service Manual / Frame and Bumpers / Bumpers / Removal and installation / Front bumper

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0216