Toyota
Dodge Durango
 Service Manual
Emission Control Systems » Evaporative emission controls » Removal and installation
Evaporation (evap) canister

The EVAP canister is located below the vehicle, inside the left frame rail, in front of the fuel tank (Fig. 21).

REMOVAL

(1) Raise vehicle.

(2) Disconnect vacuum lines at EVAP canister.

Note location of lines before removal.

(3) Remove canister mounting nut.

Fig. 21 EVAP Canister Location Fig. 21 EVAP Canister Location

1 - LEFT FRAME RAIL

2 - RUBBER GROMMETS (2)

3 - LOCATING PINS (2)

4 - EVAP CANISTER

5 - MOUNTING NUT

6 - MOUNTING BRACKET

(4) Remove canister from mounting bracket.

INSTALLATION

(1) Position canister locating pins into mounting bracket grommets (Fig. 21) and install mounting nut.

(2) Tighten mounting nut to 17-24 N*m (150-210 in. lbs.) torque.

(3) Connect vacuum lines at canister.

(4) Lower vehicle

    More about «Removal and installation»:

    Pcv valve-4.7L v-8 engine

    Evaporation (evap) canister

    Duty cycle evap canister purge solenoid

    Rollover valve(s)

    Leak detection pump (ldp)

    Dodge Durango Service Manual / Emission Control Systems / Evaporative emission controls / Removal and installation / Evaporation (evap) canister

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0043