Toyota
Dodge Durango
 Service Manual
Power Lock Systems » Removal and installation
Driver unlock relay

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO GROUP 8M - PASSIVE RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1) Disconnect and isolate the battery negative cable.

(2) Remove the steering column opening cover and knee blocker from the instrument panel. Refer to Steering Column Opening Cover and Knee Blocker in the Removal and Installation section of Group 8E - Instrument Panel Systems for the procedures.

(3) Reach through the outboard side of the steering column opening in the instrument panel to access the relay and fuse block on the back of the junction block (Fig. 5).

(4) Unplug the driver unlock relay from the relay and fuse block.

(5) Install the driver unlock relay by aligning the relay terminals with the cavities in the relay and fuse block and pushing the relay firmly into place.

(6) Connect the battery negative cable.

(7) Test the relay operation.

(8) Reverse the remaining removal procedures to complete the installation.

Fig. 5 Relay and Fuse Block Fig. 5 Relay and Fuse Block

1 - JUNCTION BLOCK

2 - RELAY AND FUSE BLOCK

    More about «Removal and installation»:

    Power lock switch

    Power lock motor

    Driver unlock relay

    Headlamp relay

    Horn relay

    Dodge Durango Service Manual / Power Lock Systems / Removal and installation / Driver unlock relay

    Dodge Durango Service Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0092