Toyota
Dodge Durango
 Owners Manual
Maintaining your vehicle » Bulb replacement
Bi-Halogen Headlamps - If Equipped

  1. Turn the steering wheel to the left to replace the bulb from the right hand lamp, or to the right to replace the bulb from the left hand lamp.
  2.  Turn the access cap located on the wheel liner counterclockwise to remove from liner.
  3.  Locate the headlamp bulb access cap through the opening in the wheel liner.
  4.  Firmly grasp the access cap and rotate counterclockwise to remove lamp housing.
  5.  Firmly grasp the low/high beam bulb and connector assembly and rotate counterclockwise to remove from housing.
  6.  Disconnect the electrical connector and then connect the replacement bulb.
  7. Install the bulb and connector assembly into the headlamp housing and rotate clockwise to lock in place.
  8.  Install the bulb access cap in the headlamp housing and rotate clockwise to lock it in place.
  9.  Install the access cap in the wheel liner and rotate clockwise to lock it in place.
CAUTION! Do not touch the new bulb with your fingers. Oil contamination will severely shorten bulb life. If the bulb comes in contact with any oily surface, clean the bulb with rubbing alcohol.
    More about «Bulb replacement»:

    High Intensity Discharge Headlamps (Bi-Xenon) - If Equipped

    Bi-Halogen Headlamps - If Equipped

    Front Turn Signal

    Front Fog Lamps

    Rear Liftgate Mounted Back-up Lamps

    Dodge Durango Owners Manual / Maintaining your vehicle / Bulb replacement / Bi-Halogen Headlamps - If Equipped

    Dodge Durango Owners Manual

    Categories


    © 2017-2024 Copyright www.dodurango.net
    0.0533