Dodge Durango

 Service Manual

Charging System » Removal and installation
Battery temperature sensor

The battery temperature sensor is located under vehicle battery (Fig. 5) and is attached to a mounting hole on battery tray.

REMOVAL

(1) Remove battery. Refer to Group 8A, Battery for procedures.

Fig. 5 Battery Temperature Sensor Location

1 - BATTERY TEMPERATURE SENSOR

2 - BATTERY TRAY

(2) Disconnect sensor pigtail harness from engine wire harness. Sensor pigtail harness is clipped to vehicle near its electrical connector.

(3) Pry sensor straight up from battery tray mounting hole.

INSTALLATION

(1) Feed pigtail harness through hole in top of battery tray and press sensor into top of battery tray.

(2) Connect pigtail harness.

(3) Install battery. Refer to Group 8A, Battery for procedures.

Specifications

Generator ratings

Torque chart

DESCRIPTION   TORQUE

Generator Mounting Bolt- 3.9L/5.2L/5.9L Engines . . . . . 41 N*m (30 ft. lbs.)

Generator Pivot Bolt- 3.9L/5.2L/5.9L Engines . . . . . 41 N*m (30 ft. lbs.)

Generator Vertical Mounting Bolt- 4.7L V-8 Engine . . . . . . . . . . 55 N*m (40 ft. lbs.)

Generator (long) Horizontal Mounting Bolt- 4.7L V-8 Engine . . . . . . . . . . 55 N*m (40 ft. lbs.)

Generator (short) Horizontal Mounting Bolt- 4.7L V-8 Engine . . . . . . . . . . 74 N*m (55 ft. lbs.)

Generator B+ Output Cable Terminal Nut . . . . . . . . . . . . 8.5 N*m (75 in. lbs.)

Generator

Battery temperature sensor