Toyota
Dodge Durango
 Service Manual
Fuel System » Fuel injection system » Removal and installation
Automatic shutdown (asd) relay

The ASD relay is located in the Power Distribution Center (PDC) (Fig. 17). Refer to label on PDC cover for relay location.

Fig. 17 Power Distribution Center (PDC) Location Fig. 17 Power Distribution Center (PDC) Location

1 - POWER DISTRIBUTION CENTER (PDC)

REMOVAL

(1) Remove PDC cover.

(2) Remove relay from PDC.

(3) Check condition of relay terminals and PDC connector terminals for damage or corrosion. Repair if necessary before installing relay.

(4) Check for pin height (pin height should be the same for all terminals within the PDC connector).

Repair if necessary before installing relay.

INSTALLATION

(1) Install relay to PDC.

(2) Install cover to PDC.

    More about «Removal and installation»:

    Automatic shutdown (asd) relay

    Fuel pump relay

    Oxygen sensor heater relays

    Throttle body-3.9/5.2/5.9L engines

    Throttle body-4.7L v-8 engine

    Throttle position sensor (tps)-3.9/ 5.2/5.9L engines

    Throttle position sensor (tps)-4.7L v-8 engine

    Idle air control (iac) motor-3.9/5.2/ 5.9L engines

    Idle air control (iac) motor-4.7L v-8 engine

    Manifold absolute pressure (map) sensor-3.9/5.2/5.9L engines

    Manifold absolute pressure (map) sensor-4.7L v-8 engine

    Powertrain control module (pcm)

    Oxygen sensor

    Air cleaner element (filter)

    Engine coolant temperature sensor-3.9/5.2/5.9L engines

    Engine coolant temperature sensor-4.7L v-8 engine

    Intake manifold air temperature sensor-3.9/5.2/5.9L engines

    Intake manifold air temperature sensor-4.7L v-8 engine

    Power steering pressure switch

    Dodge Durango Service Manual / Fuel System / Fuel injection system / Removal and installation / Automatic shutdown (asd) relay

    Dodge Durango Service Manual

    Categories


    © 2017-2019 Copyright www.dodurango.net
    0.0025