Dodge Durango

 Service Manual

Fuel System » Fuel injection system » Removal and installation
Air cleaner element (filter)

REMOVAL

Housing removal is not necessary for element (filter) replacement.

(1) Pry up spring clips from housing cover (spring clips retain cover to housing).

(2) Release housing cover from locating tabs on housing (Fig. 33) and remove cover.

(3) Remove air cleaner element (filter) from housing.

(4) Clean inside of housing before replacing element.

INSTALLATION

(1) Install element into housing.

(2) Position housing cover into housing locating tabs.

(3) Pry up spring clips and lock cover to housing.

Automatic shutdown (asd) relay

Fuel pump relay

Oxygen sensor heater relays

Throttle body-3.9/5.2/5.9L engines

Throttle body-4.7L v-8 engine

Throttle position sensor (tps)-3.9/ 5.2/5.9L engines

Throttle position sensor (tps)-4.7L v-8 engine

Idle air control (iac) motor-3.9/5.2/ 5.9L engines

Idle air control (iac) motor-4.7L v-8 engine

Manifold absolute pressure (map) sensor-3.9/5.2/5.9L engines

Manifold absolute pressure (map) sensor-4.7L v-8 engine

Powertrain control module (pcm)

Oxygen sensor

Air cleaner element (filter)

Engine coolant temperature sensor-3.9/5.2/5.9L engines

Engine coolant temperature sensor-4.7L v-8 engine

Intake manifold air temperature sensor-3.9/5.2/5.9L engines

Intake manifold air temperature sensor-4.7L v-8 engine

Power steering pressure switch